Sega House of the Dead Instrukcja Użytkownika

− 129 −CIRCUIT PROTECTOR15. TROUBLESHOOTING15 −１ PROBLEMS NOT INVOLVING THE GAME BOARDIn case a problem occurs, first check wiring connector connecti

− 138 −Error 28DISPLAY This Game Disk is Not Acceptable.CAUSE The game disk cannot be read correctly.COUNTERMEASURES Exchange the game disk for a prop

− 139 −Error 37DISPLAY Verifying Game Program Failed.CAUSE The program image is unverified due to the program image notexisting on the game disk or se

− 140 −TRUSS SCREW (3), blackM4×40, large flat washer used15 −３ REPLACING THE FUSE● Fuse replacements other than those specified can cause accidentsan

− 141 −FUSE 0.2 A, 250 V514-5143-200 or 514-5146-200③ Unlock and remove side door R.PHOTO 15. 3 b④ Exchange the fuse.PHOTO 15. 3 c

− 142 −16. GAME BOARD● In order to prevent electric shock and short circuit hazards, be sure toturn power off before performing work.● Be careful not

− 143 −TRUSS SCREW (3), blackM4×40, large flat washer used16 −１ REMOVING THE GAME BOARDThe game board (LINDBERGH board) is found, from the facing the

− 144 −SCREW (2)M4×30, w/flat & spring washers④Disconnect all connectors attached tothe LINDBERGH board.PHOTO 16. 1 c⑤ Remove the two screws holdi

− 145 −SCREW (4)M4×12, w/flat & spring washers⑧ Remove the four screws and remove the LINDBERGH board.PHOTO 16. 1 f

− 146 −Board number stickerDIP SWKEY CHIP16 −２ COMPOSITION OF THE GAME BOARD● The game board becomes the game board for this product once thekey chip

− 147 −17. DESIGN RELATED PARTSFor the Warning Display stickers, refer to Section 1.BILLBOARD SIDE PLATE LHDF-0558BILLBOARD PLATEHDF-0553STICKER BILL

− 130 −PROBLEMS CAUSE COUNTERMEASURESControl Unit (Gun)sighting is notsatisfactory.The Control Unit(Gun) does notappear to beoperating correctly.The f

− 131 −FRONT PANELTRUSS SCREW (4), blackM4×12, large flat washer usedRemoving or attaching of the mask must be carried out by at least twopeople, one

− 132 −SCREW (6), blackM4×10, w/flat & spring washersDisconnect the connectors.③Disconnect the two connectors.PHOTO 15. 1 c④ Remove the six screws

− 133 −SCREW (5), blackM4×8, w/flat & spring washersJOINT BRACKETU NUT (2)M3, flat metal & plastic washers usedLED BOARD838-13145R02⑥ The mask

− 134 −U NUT (2)M3, flat metal & plastic washers usedLED BOARD838-13145R02⑨After exchanging the LED board enter TEST Mode and perform a lighting t

− 135 −15 −２ ERROR CODES● If an error code is displayed get on-site maintenance personnel orother qualified professional to look at it. An unqualified

− 136 −Error 06DISPLAY I/O Device Not Found.CAUSE The LINDBERGH board's I/O board cannot be found.COUNTERMEASURES Send the LINDBERGH board in for

− 137 −Error 14DISPLAY Network firmware version does not fulfill the game spec.Required version XX.XX.CAUSE The firmware version installed on either t